Engine prestart checks, 7. engine prestart checks – Miller Electric Big Blue 602P User Manual

Page 24

Advertising
background image

OM-491 Page 20

Return To Table Of Contents

Ref. 802 168-E

5-7.

Engine Prestart Checks

.

Check all engine fluids daily.

Engine must be cold and on a level surface.
Unit is shipped with 20W break-in oil.

The Automatic shutdown system stops en-
gine if fuel level or oil pressure is too low, or
coolant temperature is too high.

.

This unit has a low oil pressure shut-
down switch. However, some condi-
tions may cause engine damage before
the engine shuts down. Check oil level
often and do not use the oil pressure
shutdown system to monitor oil level.

Follow run-in procedure in engine manual.
If unburned fuel and oil collect in exhaust
pipe during run-in, see Section 11.

Fuel

Y

Do not use gasoline. Gasoline will
damage engine.

The unit is shipped with enough fuel to pre-
vent air from entering fuel system but not
enough fuel to prevent low fuel shutdown.
Add fresh diesel fuel before starting to pre-
vent low fuel shutdown (see engine mainte-

nance label for fuel specifications). Leave
filler neck empty to allow room for
expansion.

Do not run out of fuel or air will enter fuel sys-
tem and cause starting problems. See en-
gine manual to bleed air from fuel system.

Oil

After fueling, check oil with unit on level sur-
face. If oil is not up to full mark on dipstick,
add oil (see maintenance label).

Coolant

Check coolant level in radiator before start-
ing unit the first time. If necessary, add cool-
ant to radiator until coolant level is at bottom
of filler neck.

Check coolant level in recovery tank daily.
If necessary, add coolant to recovery tank
until coolant level is between Cold Full and
Hot Full levels. If recovery tank coolant level
was low, also check coolant level in radiator.
Add coolant if level is below bottom of radia-
tor filler neck.

Unit is shipped with an engine coolant mix-
ture of water and ethylene glycol base anti-

freeze rated to −34

°

F (−37

°

C). Add anti-

freeze to mixture if using the unit in tempera-
tures below −34

°

F (−37

°

C).

Keep radiator and air intake clean and free
of dirt.

Y

Incorrect engine temperature can
damage engine. Do not run engine
without a properly working thermo-
stat and radiator cap.

.

To improve cold weather starting:

Use Starting Aid switch (see Section
6-1 or 7-1).

Keep battery in good condition. Store
battery in warm area.

Use fuel formulated for cold weather
(diesel fuel can gel in cold weather).
Contact local fuel supplier for fuel in-
formation.

Use correct grade oil for cold weather
(see Section 9-2
).

Full

Full

Capacity: 12 qt (11.4L)

Diesel

Full

Hot Full

Cold Full

Check radiator coolant level when

fluid is low in recovery tank.

Coolant Recovery Tank

Advertising
This manual is related to the following products: