Meridian America 541 - Manual (Page 55)

Setting up sources
49
The 541 Surround Controller provides six sources corresponding
to the following source selection keys on the remote control:
CD, Radio, TV, Tape1 (or LP), VCR1, and LD.
When the surround controller is set to one of the standard
settings the six sources are set up with standard labels and
inputs, as shown in the table below.
Source Audio Sensitivity Video Preset
Input Input
CD A2 2.0V LV Music
Radio A3 2.0V LV Music
TV A5 1.4V V2 ProLogic
Tape1 A1 1.4V LV Music
VCR1 A6 1.4V V3 ProLogic
LDisc A4 2.0V V1 Cinema
LP A1 2.0V Blank Music
If the configuration you want is not catered for by one of the
standard settings, you can configure each source individually.
For most settings there is a last valid, or L.V., option that leaves
the corresponding setting unchanged from its previous value
when the source is selected. For example, selecting CD after TV
would leave the TV picture.
For each source you can configure:
❍ The preset to be used.
❍ The label used for it on the front panel display, from over 50
alternative labels.
❍ The audio and video inputs it selects.
❍ The input sensitivity.
❍ The comms type and address, to identify other Meridian 500
Series equipment.
The procedure for doing this is as follows.
Setting up sources