Meridian America 541 - Manual (Page 56)

Setting up sources
50
To configure a source
● Turn off the control unit, using the power switch on the back
panel.
● Turn on the power again while holding down the Display key
on the front panel.
The display will show:
Config
● Press Source until the left-hand pair of characters identifies
the source you want to configure.
For example, to configure the CD
source the display initially shows:
CD Music
The options are summarised in the table opposite:
To change an option
● Press Copy (front panel) or > and < (remote) to change. The
left-hand side of the display shows the source you are
configuring, and the right-hand side shows the current value
of the option.
● Press A or V to step between the alternative values for the
option.
When you have finished programming sources:
● Switch off at the back panel, and then switch on again to
restore normal operation.