Surface cooking, Smoothtop surface, Cooking areas – Maytag 700 User Manual

Page 7: Hot surface light, Warming center

Advertising
background image

6

Smoothtop Surface Notes:

Cooktop may emit light smoke and odor the first few

times the cooktop is used. This is normal.

Smoothtop cooktops retain heat for a period of time

after the element is turned off. Turn the elements off
a few minutes before food is completely cooked and use
the retained heat to complete cooking. When the hot
surface light turns off, the cooking area will be cool
enough to touch. Because of the way they retain heat, the
smoothtop elements will not respond to changes in
settings as quickly as coil elements.

• In the event of a potential boilover, remove the pan from

the cooking surface.

Never attempt to lift the cooktop.

• The smoothtop surface may appear discolored when it is

hot. This is normal and will disappear when the surface
cools.

Smoothtop Surface

Cooking Areas

The cooking areas on your range are identified by permanent
circles on the smoothtop surface. For most efficient cooking,
fit the pan size to the element size.

Pans should not extend more than

1

/

2

to 1-inch beyond

the cooking area.

When a control is turned on, a glow can be seen through the
smoothtop surface. The element will cycle on and off to
maintain the preset heat setting, even on Hi.

For more information on cookware, refer to Cookware
Recommendations on page 7 and “Cooking Made Simple”
booklet included with your range.

WARMING CENTER

SINGLE

ELEMENT

DUAL

ELEMENT

Hot Surface Light

The Hot Surface indicator light is located on the
control panel. The light will be illuminated when
any cooking area is hot. It will remain on, even
after the control is turned off, until the area has cooled.

Surface Cooking

Warming Center

Use the Warming Center to keep hot cooked foods warm, such
as vegetables, gravies and oven-safe dinner plates.

Setting the Control:

1. Push in and turn the knob. Warming

temperatures are approximate and are
indicated on the control from Min. to
Max. The control can be set to any
position between Min. and Max.

2. When done, turn the control to Off and

remove food. The Hot Surface indicator
light will go off when the Warming Center
surface has cooled.

Notes:

Never warm food for longer than one hour (eggs for 30

minutes), as food quality may deteriorate.

• Do not heat cold food on the Warming Center.

• Heat settings will vary depending on type and amount of

food. Always hold food at proper food temperatures.
USDA recommends food temperatures between 140

°-

170

° F.

Warming Center Notes:

• Use only cookware and dishes recommended as safe for

oven and cooktop use.

• Always use oven mitts when removing food from the

Warming Center as cookware and plates will be hot.

• All foods should be covered with a lid or aluminum foil to

maintain food quality.

• When warming pastries and breads the cover should have

an opening to allow moisture to escape.

• Do not use plastic wrap to cover foods. Plastic may melt

on to the surface and be very difficult to clean.

Suggested Settings

Setting

Type of food

Min. - 2

Breads/Pastries

Gravies

Casseroles

Eggs

2 - 5

Dinner Plate with Food

Sauces

Soups (Cream)

Stews

Vegetables

Meats

5 - Max.

Fried Foods

Hot Beverages

Soups (Liquid)

Advertising