Control panel, Typical installations – Miller Electric S-32S User Manual
Page 2
Control Panel
2
Work
BASIC SET-UP -– HOT WIRE
For MIG welding, use the
optional Gas Solenoid Valve.
Constant-Current
and Constant-Voltage
DC Power Sources
Electrode/Welding Cable
Electrode/Welding Cable
Remote Contactor Cord
Work
For MIG welding, use the
optional Gas Solenoid Valve.
WITH OPTIONAL EXTERNAL SECONDARY CONTACTOR
-– COLD WIRE
Note: The secondary contactor can be wired to operate off 115 VAC or powered
off a 12 VDC battery of an engine driven welder.
10 ft. (3 m) 115 VAC Primary Cord (Connect to power source 115 VAC supply, if available.)
115 VAC/12 VDC
Secondary Contactor
Electrode/Welding Cable
To Wire Feeder Trigger Receptacle
To Gun Trigger
Constant-Current
DC Power Sources
Not Having a Weld
Output Contactor
2
1
Typical Installations
1. Power Control Switch
2. Wire Speed Control
3. CC/CV Switch