Motorola DSR315 - Manual (Page 18)

1
6
Verifying Your TV, DVD, VCR and AUX Mode Codes
You can verify the accepted programming codes for each mode by following these
steps.
1. Press the TV key for at least three seconds—until the LED blinks.
2. Press the "INFO" key.
3. The LED will blink, indicating the code of your TV in the following
sequence. For example, if your TV code is for a Tandy brand TV (code 1005)
the blink pattern will be:
- Pause>long blink "1;"
- Pause>short blink "0;"
- Pause>short blink "0;"
- Pause>long blink, long blink, long blink, long blink, long blink "5."
A zero in the code will always be represented by a short blink.
Volume Control Crossover
Your remote control unit is programmed from the factory to control the volume of
your television set when you are using the remote control in the SAT or TV mode.
The SAT mode can be programmed to control the TV audio while in SAT mode.
To program your remote control for this function:
• Press the SAT mode key until it flashes.
• While the SAT mode key is flashing, press and release the TV mode key.
• The SAT mode key will blink three times to signify acceptance.
• Press the SAT mode key to complete the programming sequence.
• The remote control will now control the volume of the TV when in the SAT
mode.
The SAT mode can be programmed to control the audio from an audio device
programmed into AUX. To program your remote control for this function:
• Program the AUX mode with an audio device.
• Press the SAT mode key until it flashes.
• While the SAT mode key is flashing, press and release the AUX mode key.
• Press the SAT mode key to complete the programming sequence.
• The remote control will now control the volume of the audio device (AUX)
when in the SAT mode.
The AUX mode can be programmed to control the audio from the TV. To program
your remote control for this function: