Setting up and using tv inputs, continued – MITSUBISHI ELECTRIC Mitsubishi Electric Laservue L75-A94 User Manual
Page 10
10
1. Basic Setup and Operation
For assistance call 1(877) 675-2224
Settin g Up Inputs with Auto Input Sensing
Learn more about Auto Input Sensing on page 27 .
1.
Power on the TV.
2.
Power on the devices to ensure detection.
3.
Connect one device to the TV, making note of the
TV input jack.
The TV will display the New Device Found screen if
the connection type is detectable.
4.
Highlight the device type in the on-screen list and
press ENTER. The name you select here will appear
in the Input Selection menu.
Sample New Device Found screen.
5.
Press EXIT to close the New Device Found screen.
6.
Repeat the preceding steps for each additional
device you want to add.
Setting Up and Using TV Inputs, continued
More About the Input Selection Menu
•
To assign helpful names to the icons, see the
Inputs > Name menu.
•
To remove unwanted Antenna or HDMI device icons
from the Input Selection menu, see the Inputs >
Name menu.
•
To rearrange the icons, use the Inputs > Order
menu.
Detailed information on using these menus is in the sup-
plemental Owner’s Guide at www.mitsubishi-tv.com.
Selecting an In put to Watch
1.
Press INPUT.
2.
Press and to highlight an
input icon.
Sample Input Selection menu, DVD input selected
3.
Press ENTER to switch to the input.
Note: In most cases, to see a named icon for a con-
nected device (as in the samples), you must fi rst
assign a name either
•
When the device is first connected and the
New Device Found menu offers a choice
of names.
•
By using the Inputs > Name menu to
assign or change a name at any time after
the TV has detected the connection.
Wa tching Broadcast TV
TV Connected to an Antenna or Direct Cable
Service (no cable box)
Note: Perform channel memorization to enable recep-
tion of digital channels. See page 7 .
1.
Press INPUT to display the Input Selection menu.
2.
Highlight the antenna or cable icon and press ENTER.
Sample Input Selection menu, antenna input selected
3.
To tune to a channel from the ANT input, use any of
these methods.
•
Enter the channel number using the number
keys on the remote control and press
ENTER
.
For a two-part digital channel, such as 3-1,
press
3
—
CANCEL 1
ENTER
.
• Press
CH to change channels one channel at
a time.
•
Press and hold CH to speed through channels.
• Press
LAST to return to the previous channel.
•
Use the Fav (Favorites) feature to tune to up to
nine favorite channels. See page 19 .
• Press
GUIDE to display ChannelView channel
listings. Highlight a channel number, then
press
ENTER
to tune.
•
Set up ChannelView custom channel banks
and use the CH key to tune within predefined
groups of channels.