MITSUBISHI ELECTRIC Mitsubishi Electric Laservue L75-A94 - Manual (Page 9)

1. Basic Setup and Operation 9
For assistance call 1(877) 675-2224
1. Install batteries in the remote control. See page 5 .
2. Aim the emitter (bulb)
end of the remote control
at the TV and press the
POWER key
. Wait for the
Welcome screen.
3. If you wish to change the
menu language to Español,
press and press ENTER.
4. Press to move to the
energy-mode selections.
Select Home.
5. Press to highlight EXIT.
Press ENTER to clear the menu.
First-Time Power-On
Settin g Up and Using TV Inputs
Welcome Screen Energy Options
• Mitsubishi recommends the Home setting,
which uses power within ENERGY STAR®
guidelines.
• The Retail setting looks best under the bright
lighting often found in commercial settings.
In this mode, the TV uses power in excess of
ENERGY STAR guidelines.
This table compares energy choices offered in the
Welcome screen.
Home Retail
Picture Mode Bright Super Brilliant
Ambient Light
Sensor Sensitivity Maximum Off
Use the Picture > Video menu to change the
Picture Mode. Use the Setup > Energy menu to
control sensitivity of the Ambient Light Sensor.
The ANT ( Antenna) Input
If using an antenna or direct cable service (no cable
box), connect the incoming coaxial cable to the TV’s
ANT input. Refer to page 16 .
You must perform a channel scan to enable recep-
tion of digital channels. If you skip this step, the TV
can receive only analog channels. The channel scan
will search for high-definition and standard-definition
channels available in your area. Note: Direct cable
service will not include scrambled or premium chan-
nels.
M emorizing Channels with Channel Scan
1. Power on the TV.
2. Press MENU and open the Setup > Channel menu.
Start channel memorization from the Setup > Channel
menu.
3. Press to enter the menu.
4. Highlight Ant Air if connected to an
over-the-air antenna. Highlight Ant
Cable for service over direct cable
(no cable box). Press ENTER to add a
check.
5. Select the scan type.
•
For first-time setup, highlight All channels.
• To scan for channels not already in memory,
highlight Add only new channels. Press
ENTER to add a check.
6. Highlight Scan and press ENTER.
Channel memorization may take up
to 15 minutes to complete.
To stop channel memorization before completion,
press CANCEL.
At any time after Channel Scan,
• Use the Setup > Channel > Edit menu to add or
delete individual channels to or from memory.
• Repeat the All channels scan if you reposition the
antenna or move the TV to a new geographic area
with a different channel line-up.