Rf830, Rf830-ap – Multitech ROUTEFINDER RF830-AP User Manual
Page 13
Chapter 2 – Installation
Multi-Tech Systems, Inc. RouteFinder SOHO RF820/RF820-AP & RF830/RF830-AP User Guide (S000399E)
13
RF830
1.
Turn the power off on all network devices (PCs, cable modems, DSL modems, analog modems, ISDN
TAs, and the router).
2.
Plug one end of a RJ-45 cable into the Ethernet port on the PC and other into one of the LAN port on the
RouteFinder. (If you have more than one PC, connect the others in the same way to the other LAN ports).
3.
Connect a network cable from the DSL modem or cable modem to the WAN port on the RouteFinder. A
second WAN port is provided for connecting a second DSL modem or cable modem that uses a different
Internet Service Provider (ISP). This gives you the option to switch from one ISP to another in case one
provider is not available.
4.
Connect the provided power supply cable to the 12VDC power port on the back of the RouteFinder, and
plug the other end of the power supply into an AC power outlet as shown.
RF830-AP
Use the cabling procedures above and attach the wireless antenna. See the Back Panel section earlier in this
chapter for the location of the antenna connector.
Note:
The antenna must be attached in order for the RouteFinder to be operational.