Rf820/rf820-ap and rf830/rf830-ap wizard setup – Multitech ROUTEFINDER RF830-AP User Manual
Page 21
Chapter 4 – Configuring the RouteFinder
Multi-Tech Systems, Inc. RouteFinder SOHO RF820/RF820-AP & RF830/RF830-AP User Guide (S000399E)
21
Wizard Setup
RF820/RF820-AP and RF830/RF830-AP Wizard Setup
Click the Wizard Setup button located under the Menu Bar. The following screen displays.
Use the same directions for the RF820/RF820-AP and RF830/RF830-AP.
Screen Notes:
•
PPP Client for Cellular/Analog Modem Backup is available on the RF820/RF820-AP only.
•
The RF830/RF830-AP has two WAN ports; the RF820/RF820-AP only one. A WAN 2 section
displays on the RF830/RF830-AP Wizard Setup screen for configuring this second port.
•
If you are using the AP build, a section labeled WLAN (inset shown on the right of the screen
shot) displays after you select Independent Subnet on the Network Setup > Wireless LAN
screen.
LAN
IP Address – 192.168.2.1 defaults into this field.
Subnet Mask – 255.255.255.0 defaults into this field. These should be acceptable for your site.