Moxa Technologies UC-7110 - Manual (Page 20)

UC-7110 Series User’s Manual Getting Started
2-4
Configuring the Ethernet Interface
In this section we use the serial console to explain how to modify UC-7110’s network settings.
1. Change directories by issuing the command cd /mnt/etc.
2. Type the command vi rc to use VI Editor to edit the configuration file. The IP addresses for
UC-7110’s LAN1 and LAN2 are given as
ifconfig eth0 192.168.3.127
ifconfig eth1 192.168.4.127
as shown in the following figure. Edit these two lines to modify the static IP addresses.