Developing your applications, Installing the uc-7110 tool chain, Developing your applications -6 – Moxa Technologies UC-7110 User Manual
Page 22: Installing the uc-7110 tool chain -6
UC-7110 Series User’s Manual
Getting Started
2-6
Developing Your Applications
Step 1:
Connect UC-7110 to a Linux PC.
Step 2:
Install Tool Chain (GNU Cross Compiler & uClibc).
Step 3:
Configure cross compiler and uClibc environment
variables.
Step 4:
Code & compile your program.
Step 5:
Download program to UC-7110 via FTP or NFS.
Step 6:
Debug the program. If the program is OK, proceed to
Step 7. If the program needs to be modified, go back to
Step 4.
Step 7:
Back up the user directory, and distribute the code to
additional UC-7110 units.
x
x86
Cross
Compiler
Installing the UC-7110 Tool Chain
The PC must have the Linux Operating System pre-installed to install the UC-7110 GNU Tool
Chain. Redhat 7.3/8.0 and compatible versions are recommended. The Tool Chain requires about
100 MB of hard disk space (on your PC). The UC-7110 Tool Chain can be found on the UC-7110
CD. To install Tool Chain, insert the CD into your PC and then issue the following command:
#mount /dev/cdrom /mnt/cdrom
Next, run the following script from the root to installs the compilers, linkers, and libraries in the
/usr/local directory:
#sh /mnt/cdrom/tool-chain/arm-elf-tools-20030314.sh
The Tool Chain installation will take a few minutes to complete.
ATTENTION
You can download the Tool Chain from Moxa’s website (go to the UC-7110 product page, click
on the Documentation & Drivers link, and then click on Go under Driver & Software
Downloads.
The Tool Chain is also available on th
website at the following link:
.