Marmitek 300 - Manual (Page 7)

The image and sound are perfect, but the IR return signal does not work.
Check the following guidelines:
•
Depending on local circumstances, the 2.4GHz A/V signal can have a larger range than
the 433MHz signal of the IR receiver. Try testing shorter distances.
• Only use new (fully charged), non-rechargeable, alkaline AAA batteries for your IR recei-
ver.
• Check whether the light on the IR receiver flashes red when using the remote control.
• Is the IR LED correctly connected to the transmitter?
• Is the IR LED correctly attached to the IR screen of I/V device?
• Moving the IR receiver can often solve the problem. Just moving it 30 cm to the left or
right can make a big difference.
I do see an image, but do not get any sound.
The Invisible Scart 300™ can transmit analogue stereo signals, such as e.g. Dolby Surround.
Digital systems such as Dolby 5.1 or Dolby Digital cannot be transmitted.
Does the Invisible Scart 300™ cause a conflict with my wireless network (WLAN)?
Both systems use the same frequency band (2.4GHz). Some interference may occur. The
Invisible Scart 300™ can use different channels within the frequency band (A, B, C, D).
Choose the channel that produces the least interference.
Can I combine multiple receivers?
Yes, the signal you receive will however be the same on all receivers.
Can I combine multiple transmitters?
You can use a maximum of 4 transmitters in combination with one or more receivers. You can
set up 4 different channels for the transmitters (A, B, C, D). The IR return channel cannot be
set to a different value, which means it works the same for the entire system. The Invisible
Scart 300™ transmitters and receivers also work with the transmitters and receivers of the
GigaVideo45 and the Invisible Scart 200™.
Has your question not been answered? Then go to www.marmitek.com for more information.
8 MARMITEK
20129_20060817_UG_scart300 26-09-2006 11:02 Pagina 8