Marantz LN-11S1A - Manual (Page 14)

10
B
EF
O
RE
U
SE
N
A
M
E O
F P
A
RT
S
B
A
SIC
O
PE
RA
TIO
N
A
D
VA
N
CE
D
O
PE
RA
TIO
N
REM
OT
E C
ON
TR
OLL
ER
OP
ER
ATI
ON
TR
OU
BLE
SH
OO
TIN
G
O
TH
ER
S
SE
TU
P
CONNECTING THE LN-11S1A
Connect the LN-11S1A to a power supply and the
projector.
1.
Install the AC/DC adapter and attach the AC
cable to the AC/DC adapter.
Refer to Figure 26. During use, always use
the supplied AC/DC adapter. Never use an
AC/DC adapter other than that supplied as
it may result in an accident or damage to
the equipment.
Figure 26
Note:
Three types of AC cable are supplied with this unit.
Use the AC cable appropriate for the region in
which the unit will be used.
2.
Connect the TRIG. 2 output jack on the
VP11 or VP15 series projector to the +12 V
TRIGGER IN jack located on the lens slider.
3.
Plug the AC cable into a power outlet.
4.
Connect the AC/DC adapter’s output plug
to the +5 V DC jack on the lens slider.
When power is supplied to the LN-11S1A,
the POWER ON indicator will light blue.
SETUP
MOUNTING THE LN-11S1A LENS
Mount the lens to the projector, whose operations
have already been confirmed, according to the
procedure given below.
1. Attach the anamorphic lens unit to the
main unit at two locations by passing
the supplied decorative screws (M3 x
8) through the spring washers and flat
washers. Refer to Figure 24 and 25.
When mounting the lens unit, be sure to
mount it so that the anamorphic lens unit
does not strike the projector lens when in
the operating position.
Figure 24
Figure 25
MOUNTING THE LN-11S1A
(ON THE FLOOR)
Mount the assembled LN-11S1A to the projector.
Refer to Figure 20.
Figure 20
1. Spread a soft cloth on a stable, horizontal
surface to protect against scratching, and
carefully place the projector upside down
on the cloth.
Align the mounting holes on the LN-11S1A
base plate with the lens slider attached
with the two ceiling mount kit mounting
screw holes located on the lens side of
the projector. Refer to Figure 22. Attach
securely using two M8x10 hexagonal set
screws supplied with the LN-11S1A. Refer
to Figure 21.
Figure 21
Figure 22
Figure 23
2.
It is important to completely finish mounting
the projector and making initial settings
before mounting and adjusting the LN-
11S1A anamorphic lens. Perform necessary
procedures such as focus adjustment while
referring to the projector’s user’s guide.
Once the required projector settings have
been made, proceed with lens mounting
and adjustment.