Marantz CD6002 - Manual (Page 15)

12
ENGLISH
BASIC OPERATIONS –AUDIO CD–
PLAYING CDS
1 2, 3 4
4
2, 3
1. Press the POWER button on the player to turn
on the power.
2. Press the OPEN/CLOSE 0 button on the player
or on the remote control. Place the CD to be
played in the extended disc tray while ensuring
that the label with the printed text is facing up.
In the case of a single (8 cm) CD, align it with
the indentation in the center of the tray.
CONNECTIONS
REMOTE CONTROL CONNECTION
By using the remote control cable provided, connecting this player to additional Marantz audio equipment
enables the connected equipment to be remote controlled as a single audio system.
• When connecting equipment incorporating a remote sensor, connect the “remote control out” connector
of the equipment to the “remote control in” jack of the CD player.
When doing this, set this player’s switch to “EXTERNAL.” This will stop its remote control IR receiver
from operating and the player can now be controlled via the remote control IR receiver of the attached
equipment.
• When using this CD player alone, set the switch to “INTERNAL.”
AC IN AC IN
INTERNAL INTERNAL
EXTERNAL EXTERNAL
OUT OUT
IN IN L L R R OPTICAL OPTICAL COAXIAL COAXIAL
DIGITAL AUDIO OUT DIGITAL AUDIO OUT REMOTE CONTROL REMOTE CONTROL ANALOG OUTPUT ANALOG OUTPUT MODEL NO. CD6002 MODEL NO. CD6002
: Signal fl ow
Amplifi er
Remote connector cable (supplied)
Set to “EXTERNAL.”
CONNECTING THE POWER
SUPPLY
1. Plug the power cable into AC IN jack on the
back panel.
2. Turn on the power switch of the audio unit
(amplifier, etc.) that is connected with this unit.
Set the selector on the connected unit to this
unit.
3. Plug the power cable into an AC outlet.