Marantz RC5400 - Manual (Page 11)

Modes
The RC5400 has different “M odes ”. When you activate the RC5400
for the first time, it starts up in USE mode allowing you to
immediately operate your devices. In USE mode, the center of
LOWER TOOL BAR displays the MODE
icon .Tap and hold the
MODE icon more than 3 seconds. The Mode Menu page will
appeares. If the center of LOWER TOOL BAR shows another icon,
like
, tap it to reveal the Mode Menu and press the Left
Function button labeled Exit to return to USE mode.
Note If you do not see the Mode icon; it has been deactivated via the
Setup. To enable this function, the Mode Menu setting in the
Setup has to be set to Active (see page 13).
Your RC5400 is capable of displaying hundreds of different control
pages. RC5400 presents you various ways to navigate to the
specific device and page easily.
Navigating the Devices
Home — The Home Page displays instant
convenient jump buttons
to the main control page of your
system devices (your Amp., TV, DVD
player etc.). These buttons
also select the Input of your Home
Theater Receiver or Preamp.
Access Home page by
pressing the HOME button
at the bottom left of the remote.
•
Device buttons in the Home page perform two actions
when pressed;
1. Jumps to the main page of the Device.
2. Changes your home theater receiver/preamp to the
appropriate input. To program for a non-Marantz
receiver/preamp, see page 28.
User Guide
Getting Started
2. Navigating the RC5400
7