Meridian America Meridian DSP - Manual (Page 11)

6
INTRODUCTION
Specification – DSP5000 and
DSP5000C
Digital inputs and outputs
• 2 x cable inputs, 32-192kHz. FIFO locks at 44.1, 48, 88.2, 96, 176.4, or
192kHz ± 150ppm (176.4 and 192kHz supported by single wire
connection and future software upgrade).
• PCM using IEC958, or MHR connection support with auto-detection.
• 1 x cable input pass-through to feed second speaker.
Signal processing
• 1 x Motorola 56303 running at 80MHz.
• 2 x 24-bit Multi-bit delta-sigma DACs with 128x oversampling.
• Crossover linear-phase ±30º at 2.3kHz.
Output stages
• Power amplifiers: Complementary bipolar design, with output-stage
error correction and twin loop design.
• Bass: 2 x 75W.
• Treble: 75W.
Acoustic
• 2
way.
• Ported bass enclosure.
• Bass/Mid drive units: 2 x 160mm (6") polypropylene high-efficiency
long-throw custom drivers.
• Treble drive unit: 1 x 25mm (1") Meridian piston in short horn,
aluminium dome with silver voice-coil.
Characteristics
• Distortion typically <0.01%, or <0.02% up to full power at all
frequencies.
• Noise and hum <-94dBr at all volume settings.
• Acoustic output typically >108dB spl @ 1m.
• Acoustic noise <15dB spl @ 1m.
• Frequency response in room response within 3dB, 35Hz-20kHz.