Specifying information about your system, Configuration options, Balance control – Meridian America Meridian DSP User Manual
Page 37: Centre menus, Communications mode, Controller mode, Diagnostic displays, Position and master/slave, Product address, System address
32
CONFIGURING THE
DSP LOUDSPEAKERS
Specifying information about your
system
You can configure the operation of the DSP loudspeakers to suit the way
your system is set up, and the way in which you want to use it.
These settings are configured automatically to appropriate values when
you choose one of the standard Type settings, and you should not normally
need to alter them; see Choosing standard settings, page 30.
To configure the DSP loudspeaker
• Turn off the DSP loudspeaker, using the power switch on the back
panel.
• Turn on the power again while holding down the 0 key on the remote.
The display will show the current setting of the first configuration option.
For example
L.
• Press
> or < to step between the options.
• Press
A or V to change the value of the current option.
The table below shows the options you can configure:
Option
Initial Value in Type 1
Position and master/slave
L.
Communications mode (500 or 200)
500
Controller mode (Auto, Con, or NCon)
Auto
System address (1–8)
S.A. 1
Product address (1–8)
P.A. 1
Volume mode (1=normal,
2/3=second/additional room)
L.E. 1
Balance control? (N or Y)
Bal. Y
Centre menus? (N or Y)
Centre N
Diagnostic displays? (N or Y)
Diag. N