Meridian America Meridian DSP - Manual (Page 19)

14
SETTING UP THE DSP
LOUDSPEAKERS
Unpacking
Before you begin installation you should ensure that your DSP
loudspeakers are the correct voltage for your local AC supply. If they are
not, do not try to install them, and contact your dealer.
You should not make any connections to the DSP loudspeakers, or to any
other component in your system, while the AC power supply is connected
and switched on.
Care when unpacking
Take great care when unpacking or re-packing the DSP loudspeakers that
you do not put undue pressure on the face containing the drive units, as
they may be damaged if pressed.
Components
Each pair of DSP loudspeakers is supplied with the following components:
• The DSP loudspeakers complete with grilles.
• Eight screw-in spikes with lock nuts and foot caps (except DSP5000C and
DSP5500HC).
• Eight rubber bumpons (DSP5000C and DSP5500HC).
• A wrench for the spikes.
• A hex wrench (3mm) for the drive units.
• Meridian System Remote, battery and user guide.
• One power cord per speaker.
• Meridian M5 lead (8m).
• Meridian S5 lead (8m).
• This user guide.
The following specific speakers include additional components:
DSP5500, DSP5500C, and DSP5500HC
• A hex wrench (8mm) for the side panels.
DSP6000 and DSP6000C
Each speaker is supplied with:
• A head unit complete with cups.
• Three knurled screw-in pillars for the head unit to sit on.
• Three plastic spacers to fit over the pillars.
• A head connection lead.
• A top glass plate for the base unit.
If any of these items is missing, please contact your dealer. We suggest that
you retain the packaging carefully for maximum protection in transit.