Moyer Diebel M-DH - Manual (Page 12)

6
OPERATION
INITIAL START-UP
Complete the installation
After the plumbing and electrical connections are made, follow the steps below to complete
the installation of your dishwasher.
1. Remove the protective covering from the exterior of the machine.
2. Remove any foreign material from the inside of the machine.
3. Make sure dishwasher power is off.
4. Turn the main water supply on.
5. Turn main power on at the main power service disconnect switch.
6. Install the scrap screens.
7. Make sure that the overflow seats securely in the tank bottom.
8. Make sure doors are fully closed.
9. The control panel is located on the lower right side of machine. Select any cycle (1, 2, 3
minutes).
10. The ON light will glow red and the machine will fill automatically.
11. When machine is full the tank heater and booster heater will begin to heat the water in the
dishwasher. Wait approximately 10 minutes for the wash tank to reach operating tempera-
ture. The temperature should be a minimum of 140F/60°C. The machine is ready for use
when the READY light (tick symbol) glows amber.
OPERATION
Operation and Use
1. Before washing make sure that:
• wall mounted on/off switch is switched on;
• water supply is open and water pressure is present;
• pump suction filters are installed in proper location;
• overflow tube is inserted in drain;
• rotating spray arms move freely;
• rinse and detergent containers are full;
2. Select required cycle. Try cycle 3 initially and switch to faster cycles only if necessary.
3. Scrap and preflush all items to be washed. Load items into the rack. Do not overload the
rack. Wash only one layer of silverware in a rack.
4. Open the door and insert the rack into machine. Close door.
5. Machine starts automatically. CYCLE light glows green.
6. Remove rack when the CYCLE light goes out.
NOTE:
Machine will not operate unless the READY light is on. Wash temperature light (ther-
mometer symbol) glows amber when wash temperature has been reached. After removing
racks from machine, DO NOT shut door as machine will start up again.