1. selecting and adjusting sharparc e control – Miller Electric Welder User Manual
Page 106
Advertising
OM-196 188 Page 100
SECTION 12 – SETTING SharpArc
E
CONTROL
12-1. Selecting And Adjusting SharpArc
E
Control
1
SharpArc
SharpArc
is used to adjust arc
cone width and arc characteristics.
Use mode select button to move >
to select SharpArc. Use Display
Control to adjust Arc setting.
SharpArc
setting range is from 0
to 20. The factory default is set at
zero (0). When Arc value is
increased toward 20, the arc cone
narrows and the weld puddle
becomes less fluid.
> Process
Sequence
SharpArc
Card
> Prg 1
Pulse
035” Steel
Argon – Oxy
1
SharpArc
> 0
SharpArc
> 10
Process
Sequence
> SharpArc
Card
>SharpArc
0
Mode
Select
Increase/Decrease
Set Desired Value
Parameter
Select
Parameter
Select
SharpArc
> 10
> SharpArc
10
Advertising