Miele KM 344 - Manual (Page 14)

Gas pressure regulator
A pressure regulator that is convertible
from natural to LP gas (Propane) is in-
cluded with the appliance. The ad-
justed pressure is for:
natural gas - 4" w.c.
LP gas - 10" w.c.
As shown in the above diagram, the in-
cluded regulator
must be used when
connecting the Miele cooktop to your
gas supply. This item has been custom-
ized by Miele to meet all applicable
safety requirements. Make sure the reg-
ulator is easily accessible for adjust-
ment after the appliance has been in-
stalled.
For convenience, an AGA or CGA ap-
proved flexible stainless steel gas hose
(accordion type) may be used between
the gas connection and the regulator.
This will allow the appliance to be lifted
out of the countertop for cleaning or
servicing. Make sure that any drawers,
cabinet doors, etc., do not rub on this
gas hose.
Do not use any regulator unless it
has been supplied by Miele. Doing
so may cause a gas leak.
If there is any doubt concerning instal-
lation contact the Miele Technical Ser-
vice Department at:
USA 1-800-999-1360
[email protected]
CDN 1-800-565-6435
[email protected]
After connecting the appliance check
all fittings for gas leaks e.g. with
soapy water.
When installed properly, the flame will
be steady and quiet. It will also have a
sharp, blue inner core that will vary in
length proportional to the burner size.
Flame adjustment will not be necessary.
Gas connection
14
gas cooktop
use pipe
dope
regulator (included)
½ " NPT