Marathon Computer AACC 2000 - Manual (Page 88)

Marathon Monitors Inc.
AACC 2000 Carbon Nov. 1, 1997
88
Set Offset 1
Use or to set the offset value of Process
Value 1 (PV1).
The offset value is in display units Press
Set Offset 2
Use or to set the offset value of
Process Value 2 (PV2), if configured.
The offset value is in display units.
Press
The table below shows the parameters which
appear after ‘
OFS.2’. These are all read only
values and are for information. Press to step
through them.
mV.1
IP1 measured value (at terminals)
mV.2
IP2 measured value (at terminals), if DC
input in Module 3 position
CJC.1
IP1 Cold Junction Compensation
CJC.2
IP2 Cold Junction Compensation
Li.1
IP1 Linearised Value
Li.2
IP2 Linearised Value
PV.SL
Shows the currently selected input
If you do not want to look at these parameters,
then press and this returns you to the ‘
iP-
LiSt’ header.
To protect the calibration against unauthorised
adjustment, return to Operator level and make
sure that the calibration parameters are hidden.
Parameters are hidden using the ‘Edit’ facility
described in Chapter 3, Access Levels
See table on
the right for
additional
parameters.