Marantz PM-11S2 - Manual (Page 10)

4
NAMES AND FUNCTIONS
BASIC CONNECTIONS
BASIC OPERA
TIONS
ADV
ANCED CONNECTIONS
ADV
ANCED OPERA
TIONS
TROUBLESHOOTING
OTHERS
ENGLISH
This section must be read before any connection is made to
the mains supply.
EQUIPMENT MAINS WORKING
SETTING
Your Marantz product has been prepared to comply with the
household power and safety requirements that exist in your area.
— Power requirements (U.S.A.) ....................AC 120V 60Hz
— Power requirements (Europe) ..............AC 230V 50/60Hz
COPYRIGHT
Recording and playback of any material may require consent.
For further information refer to the following:
— Copyright Act 1956
— Dramatic and Musical Performers Act 1958
— Performers Protection Acts 1963 and 1972
— Any subsequent statutory enactments and orders
INAPPROPRIATE PLACES FOR
INSTALLATION
To keep your amplifier in perfect working order for the longest
possible time, avoid installing the unit in the following locations.
• Wherever it will be exposed to direct sunlight
• Wherever it will be close to a heater or other heat-radiating
appliance
• Wherever the humidity is high or ventilation is poor
• Wherever it is very dusty
• Wherever it will be subject to vibration
• On top of a rickety stand or in an unstable location which is
tilted at an angle
• In an audio rack with little space at the top and bottom or other
location where the heat dissipation will be obstructed
To ensure proper heat dissipation, install the unit while
leaving clearances between the unit and wall or other
components, as shown in the figure below.
POWER ON/OFF PHONES
VOLUME A
TONE
SPEAKER
B SPEAKER
REC OUT
PRE OUT
ATT.
MC
OPERATE
PHONO
DISPLAY
SELECTOR INPUT
Left 7-7/8 ins.
(0.2 m) or more
Above 7-7/8 ins.
(0.2 m) or more
Right 7-7/8 ins.
(0.2 m) or more
Rear 7-7/8 ins.
(0.2 m) or more
7
Do not place objects on top
• Refrain from placing any objects on top of the unit.
7
Cautions on handling power cord
• Do not touch the power cord with wet hands.
• When disconnecting the power cord, always make sure that
you take hold of the plug. Yanking out or bending the cord
can damage it and/or cause electric shocks or a fire.
• Get into the habit of disconnecting the power plug before
leaving home.
BEFORE USING