Marantz PM-11S2 - Manual (Page 30)

24
NAMES AND FUNCTIONS
BASIC CONNECTIONS
BASIC OPERA
TIONS
ADV
ANCED CONNECTIONS
ADV
ANCED OPERA
TIONS
TROUBLESHOOTING
OTHERS
ADV
ANCED OPERA
TIONS
ENGLISH
ADVANCED OPERATIONS
ATT. (ATTENUATION)
ATT. button
POWER ON/OFF PHONES
VOLUME A
TONE
SPEAKER
B SPEAKER
REC OUT
PRE OUT
ATT.
MC
OPERATE
PHONO
DISPLAY
SELECTOR INPUT
ATT is a one-touch feature for reducing the volume level. When
the ATT button on either the unit or remote controller is pressed,
the volume level is attenuated.
1. When the ATT button on either the unit or the remote
controller is pressed, “ATT” flashes on the display and the
volume level is reduced.
When the ATT button is pressed again or the volume
is increased/decreased using the controls, the mode is
canceled and the original volume level is restored.
2. When the ATT button is pressed with the volume level at
-∞(muted), the display will change as it is shown below
appears for about 3 seconds, and attenuation is not
applied.
7
How to Set Attenuation Level
Attenuation level can only be set using the ATT button on the
unit. The attenuation level can be set at –20dB, -40dB, or -∞.
The factory default setting is -20dB.
1. Press and hold the ATT button on the unit for 2 seconds or
longer. The attenuation level will appear on the display.
2. The attenuation level setting value changes with each press
of the ATT button on the unit.
3. When the desired attenuation level setting appears on the
display, leave it unchanged for 2 seconds or longer to enter
the setting. Once entered, the display returns to the volume
level indication.
HOW TO OPERATE THE SIDE
ILLUMINATION
DISPLAY button
POWER ON/OFF PHONES
VOLUME A
TONE
SPEAKER
B SPEAKER
REC OUT
PRE OUT
ATT.
MC
OPERATE
PHONO
DISPLAY
SELECTOR INPUT
Illumination Lamp
The illumination lamp has an always-ON mode (factory setting)
and an always-OFF mode.
In the always-ON mode, the illumination lamp turns ON/OFF
in sync with the display.
1. With the illumination lamp lit, press and hold the DISPLAY
button for 3 seconds or longer. The illumination lamp goes
out, and the always-OFF mode is engaged.
2. To cancel the always-OFF mode and turn the illumination
lamp ON, press and hold the DISPLAY button for 3 seconds
or longer.