Meyer Sound Self-Powered Studio Monitor HM-1S - Manual (Page 7)

7
HM-1S to HM-1S Subwoofer Cable
Connector Assembly Procedure
Cable
Boot
Cord Connector
Cable Clamp Housing Contact Pins
Coupling Ring
Step 1:
Feed the end of the cable through the boot, cable clamp housing,
and coupling ring in the order and position shown.
Cable
3/8" Max.
7/32"
Step 2:
FOR STEREO CABLES: Strip cable as shown and begin soldering conductors to pins starting
with the Gray wire to pin 1, pin 2 no connection, and the White wire to pin 3.
FOR MONO CABLES: See wiring instructions on page 6.
Contact Pins
Cord Connector
Dot pin 1
indicator
3
1
Solder
9/32"
Coupling Ring
Step 3:
Align coupling ring's tabs with cord connector's side notches and push
the coupling ring onto cord connector.
Cord Connector
Cord Connector
Side notch
Tab
Tab
Step 5:
Push the boot all the way foward to seat tightly onto the cable clamp housing.
Step 4:
Push the cable clamp housing foward until it locks into the connector body
and snap the two clamps into their compartments.
Lock Clamp
Clamp
1
2 3