Motorola PMR446 - Manual (Page 14)

14
English
pressed within 5 seconds, scanning resumes.
• To stop scanning, briefly press T.
If you press PTT while the radio is scanning, the radio
transmits on the channel you were on before you started
scanning.
Skipping and Scanning
Scan has two temporary features to make it easier to use:
1. Scan advance: If the radio stops scanning on a channel
you do not want to listen to, press ] to resume
scanning for the next active channel.
2. Nuisance delete: Press and hold [ to temporarily
remove a channel from the scan list. The channel
returns the next time you use the scan feature.
Editing the Scan List
For faster scanning and to avoid hearing unwanted
transmissions, you can edit the scan list to skip channels.
• Press S until h displays and the channel number and Y
or n flash.
• Press ] or [ to select the channel you want to remove
from the scan list.
• Press T to display either Y to include the channel or n to
exclude the channel.
• Press PTT to exit.
Voice Scrambling
This feature gives you additional privacy. Anyone who is
listening on the same channel and code will hear distorted
speech, unless they have a voice scrambling code that
matches yours.
• Select the channel on which you wish to set up the voice
scrambling code.
• Press S until e shows in the display.
• Use ] or [ to select the required code. (code 0
disables the voice scrambling code).
• Press PTT to exit.
Microphone Gain
Adjusting your radio’s microphone sensitivity level helps to
minimize the possibility of unintended noises triggering a
transmission, or enhances the ability to pick up quiet
voices.
• Press S until g and ? show in the display.
• Press ] or [ to select the sensitivity level as follows:
1 - If you speak loudly, or are in a noisy environment.
2 - Suitable for most applications.
3 - If you speak softly, or are in a quiet environment.
• Press PTT to set level.
Signal Strength and Channel Busy Indicator
If another radio is transmitting on your set channel and
code w will show in the display and the red LED will flash
?????-CLS446 User Guide 25/9/03 4:11 PM Page 14