Miele KM5656 - Manual (Page 28)

What if one or more residual heat indicators flash?
Possible fault Fix
There was a power failure during use.
The burners are turned off. Turn the cooktop on as usual.
The residual heat indicators were lit
while the programming mode, e.g.
Safety Lock, Stop and Go, was
selected. The residual heat indicators will flash
for about 45 minutes after leaving the
programming mode.
The cooktop can be used as usual.
What if when the cooktop is turned off, the burner displays show A, F and
numbers?
Possible fault Fix
The touch controls could not be reset
automatically. They must be reset
manually. See, "Resetting the touch controls -
Manual reset".
If the problem persists, call Miele
Technical Service.
What if the rear burner display shows F, the front burner display shows E
and the timer shows numbers?
Possible fault Fix
Trip the circuit breaker to the cooktop
or disconnect the appliance from the
main power supply for 1 minute. If the problem persists, call Miele
Technical Service.
Frequently asked questions
28