Lamp handling precautions – Marantz Model VP-10S1 User Manual

Page 3

Advertising
background image

1

ENGLISH

FOREWORD

This section must be read carefully before any connection is
made to the mains supply.

EQUIPMENT MAINS WORKING SETTING

Your Marantz product has been prepared to comply with the
household power and safety requirements that exist in your
area.
VP-10S1 can be powered by 230V AC only.

COPYRIGHT

Recording and playback of some material may require
permission. For further information refer to the following:

-

Copyright Act 1956

-

Dramatic and Musical Performers Act 1958

-

Performers Protection Acts 1963 and 1972

-

Any subsequent statutory enactments and orders

WARNINGS

• When the projector is mounted on the ceiling, the Ceiling

Mount Kit approved by MARANTZ must be used for
installation.

• Do not look into the lens when the projector is turned on. It

could damage your eyesight.

• Unplug the projector from the wall outlet if it is not to be used

for a few days.

• When the switch is in the OFF position, the apparatus is NOT

disconnected from the AC supply mains.

• The socket-outlet shall be installed near the equipment and

shall be easily accessible.

Lamp Handling Precautions

DANGER

The P-VIP lamp is a high voltage glass mercury vapor lamp. The
lamp can break or fail to light if handled wrongly during replacement
or because of temperature in the room where the projector is being
used or stored.
Lamp life also varies according to the lamp with some even breaking
or burning out as soon as they are used the first time. If the lamp
breaks, glass fragments may be scattered inside the lamp unit and
projector, and mercury gas from the bulb may seep from the
projector’s vent.
Before use, carefully read the User Guide of the projector and the
Lamp Replacement Instructions. Remember to handle the lamp with
care. In the event of serious trouble, call for Marantz authorized dealer.

• Never look directly into the lamp with unprotected eyes while lit.

The bright light can cause sore eyes and impair vision.

• Never directly expose skin to the light of the lamp. Direct exposure

can inflame the skin.

• Do not drop, impact, subject to excessive force or otherwise

damage the lamp.

• Replacing the lamp runs the risk of burns and electric shock,

therefore shut off power supply, unplug the AC power cable from
its electrical outlet and wait at least 60 min for the lamp to cool
down before attempting to replace it.

• If the lamp breaks, unplug the AC power cable from its electrical

outlet and call for Marantz authorized dealer to replace it. Do not
replace the lamp yourself or clean up broken glass inside the
projector as this can result in cuts as well as scratching inside
the projector.

• If the projector is hung from a ceiling or installed in a high place,

it is extremely dangerous to replace the lamp. In this case, do
not replace or service the lamp yourself.

CAUTION

• The chance of the lamp breaking is high after extended use. It is

recommended to replace the lamp when near the end of its
designed life. Do not use a lamp beyond the maximum lighting
time.

• Use only Marantz original lamp units. Check the model code of

the lamp unit matches that in this User Guide.

• Before replacing the lamp, read carefully “Lamp Unit

Replacement” in this User Guide. Replace the lamp as explained
therein.

• Entrust disposal of a used lamp to a licensed industrial waste

handler or return it to the place of purchase. Do not break the
lamp or discard with general waste.

• If the lamp breaks, leave the area immediately and stay away for

at least 30 min, and ventilate the room so as not to inhale the
mercury vapor.

• If you inhale the mercury vapor, see a physician immediately.

Advertising
This manual is related to the following products: