Preparating your projector (continued), En-8, Bottom side – MITSUBISHI ELECTRIC Mitsubishi LCD Projector FL7000U User Manual
Page 8: Remote control, About the laser beam
EN-8
1
2
3
Preparating your projector (continued)
Bottom side
1 Adjustment
feet
2 Air inlet grille/Filter cover
3 Lamp
cover
Caution:
Do not replace the lamp immediately after using the
projector because the lamp would be extremely hot
and it may cause burns.
29
COMPUTER
VIDEO
S-VIDEO
DVI-D(HDCP)
HOME
Page Up
END
Page Down
AUTO POSITION
KEYSTONE
ASPECT
SPLIT
FREEZE
AV MUTE
LENS SHIFT
ZOOM / FOCUS
1
2
VOLUME
17
18
19
21
22
23
24
25
27
28
20
26
CE
MENU
ENTER
LASER
R-CLICK
1
3
4
5
6
7
8
9
11
12
13
14
15
10
16
2
Remote control
1 Laser
aperture
2 Transmission
window
3 Wired remote control jack
4 Indicator
5 POWER
button
6 VIDEO
button
7 DVI-D(HDCP)
button
8 HOME
button
9 END
button
10 Page Up and Page Down buttons
11 Mouse pointer
12 LENS SHIFT button
13 MENU button
14 ZOOM/FOCUS button
15 + , - (VOLUME) buttons
16 COLOR ENHANCER (CE) button
17 COMPUTER 1, 2 buttons
18 S-VIDEO button
19 AUTO POSITION button
20 LASER button
21
S, T, W, X buttons
22 R-CLICK button
23 ENTER button
24 KEYSTONE button
25 ASPECT button
26 SPLIT button
27 FREEZE button
28 AV MUTE button
29 Left click button
• Pressing the LASER button emits a laser beam.
Even when you keep holding down the LASER but-
ton, it is emitted only one minute. To keep emitting
it longer, press the LASER button again.
• You can disable the LASER button to prevent laser
radiation due to misuse of the button.
How to disable the LASER button
While holding the LASER button down, press the
T
button 3 times.
How to enable the LASER button
While holding the LASER button down, press the
S
button 3 times.
• Whenever the batteries are replaced, the LASER
button is enabled.
About the laser beam
This remote control is a Class 2 laser product. (Max. output: 1 mW, Wavelength: 620-640 nm)
Beam Divergence: 6 m distance about 10.0 mm x 10.0 mm (±6.0 mm)
Caution:
• Pressing the LASER button on the remote control emits a laser beam. Do not look into the laser beam directly. Do
not point the laser beam at anyone. Looking at the laser beam directly may damage eyesight.
• Use of controls or adjustments or procedures other than those specifi ed herein may result in hazardous radiation exposure.
• This remote controller cannot be repaired.
There are 2 types of labels placed on the back of the
remote control and either of them is placed on it.
or