Maytag MBV1976AA - Manual (Page 9)

8
SkyBox™ Personal Beverage
Vendor Main Assembly
Tools Needed:
• Phillips head screw driver
Parts Quantity
AA Graphic Access Cover ...........................1
BB Front Display Graphic ............................1
CC Clear Panel .................................................1
DD Light bulbs..................................................2
EE
Beverage Cards ........................................4
FF Connecting Bolts: M5 x 20 ...................
Hex-Phillips Head Cap ............................
Screws - 3 ⁄
4
” (20 mm) long...................2
STEP 1 – Install Light Bulbs
• Make sure SkyBox™ personal
beverage vendor is OFF and
the power cord is unplugged.
• Flip up the graphic access
cover (AA), exposing a screw
and the top edge of the front
graphics panel.
• Remove the screw.
• Slide the front display graphic
(BB-see page 3) up and out
of the personal beverage
vendor.
• Lift the clear panel (CC) up
and out of the unit, exposing
the sockets for the light bulbs.
STEP 2 – Install Beverage Cards
STEP 3 – Attach SkyBox™ Personal
Beverage Vendor to
SkyBase™ Stand
Assembly
• Place the SkyBox™ personal beverage vendor on the
SkyBase™ stand.
• IMPORTANT: Line up holes on bottom of SkyBox™
personal beverage vendor with holes in top of
SkyBase™ stand. Carefully thread a connecting bolt
(FF–see illustration) into each hole up through the
inside of the stand and into the hole in the SkyBox™
personal beverage vendor. Secure firmly.
FF
• Bend beverage cards (EE) back at score line, so
small fold is away from printed side.
• Gently pull out the bottom edge of the beverage
buttons toward you and slide the beverage cards
(EE) into the buttons, sandwiching them in the small
slit between the clear plastic.
EE
• Remove the two 18" fluorescent light bulbs, type
F15T8 15 watt (DD) from their packaging and install
by sliding them into the light sockets and rotating
away from you until they click into place.
• Replace the clear panel (CC) and slide the front
display graphic (BB) back into place in front of the
clear panel, behind the lower edge of the frame
opening.
DD
• Reinsert the screw.
• Flip the graphic access cover (AA) back down into
place.
AA
CC