Milan Technology MIL-S1600 - Manual (Page 15)

Installing the 100FX Module
Before installation, ensure that the power to the switch is disconnected.
The module is NOT hot-swappable. Follow the steps to install the optional
100FX Module:
1. Power the MIL-S1600 OFF before installing the 100FX Module.
2. Unscrew the thumbscrews on the blank panel. Remove the blank
panel and set aside, but do not discard it. Put the blank bracket back
in if you remove the new module.
3. Install the new 100FX Module by inserting it into the guides and
sliding it in until it stops (See Figure 3-7). Press it firmly until you feel
the module snap into place. Never force, twist or bend the 100FX
Module.
Figure 3-7. Install the 100FX module
4. Gently push the thumbscrews in and turn clockwise to tighten. Do not
over tighten the thumbscrews.
5. Power the MIL-S1600 ON, and the switch will automatically detect the
fiber module. Plug the fiber cable connector into the 100FX Module.
Check the LEDs to verify there is a link and proper connection.
12