MACKIE 8-submaster mixer - Manual (Page 53)

51
Figure 9: Modification II — PFL Figure 10: Modification III — Mix-B Source
BEFORE
cut here (C&D)
AFTER
add jumpers
(E&F)
BEFORE
cut here (G)
AFTER
add jumper (H)
II. PFL mod
This modification changes the tap point of the
SOLO bus from post-fader/post-mute (stereo) to
pre-fader/pre-mute (mono). It must be done on
each channel. For example, if you have a 24•8,
the modification must be done on all 24 input
channels.
See Figure 9. This modification takes place on
each channel strip in an area under the channel
fader.
1. Remove power cable.
2. Cut the conductor at Point C.
3. Cut the conductor at Point D.
4. Add a jumper at Point E.
5. Add another jumper at Point F.
6. Repeat for all input channels.
III. Mix-B Source mod
This modification changes the tap point of the
Mix-B Source switch (engaged) from pre-fader/
pre-mute to post-fader/post-mute. It must be
done on each channel. For example, if you have
a 24•8, the modification must be done on all 24
input channels.
See Figure 10. This modification takes place
on each channel strip in an area under the Mix-
B Source switch.
1. Remove power cable.
2. Cut the conductor at Point G.
3. Add a jumper at Point H.
4. Repeat for all input channels.
ADD-ONS
SPECS
ETC.