Miller Electric SW3 - Manual (Page 4)

Litho in USA
Distributed by:
Equipment and Options Stock No. Description Qty. Price
SSW-2020 ATT #903 826 Stationary, air-operated, 230 VAC, 50/60 Hz
SSW-2040 ATT #903 827 Stationary, air-operated, 460 VAC, 50/60 Hz
Tongs
Order separately Ordered by the pair. One pair of tips included with each pair of tongs.
See page 3 for tong/tip combinations
Tips
Order spares or additional types One pair of tips included with each pair of tongs.
See page 3 for tips that can be ordered in pairs or individually
Accessories
Tip Dresser #040 228
Coolant Systems
Coolmate ™ 3 #043 007 115 VAC 5/8-18 left-hand inlet/outlet receptacles
#043 008 230 VAC 5/8-18 left-hand inlet/outlet receptacles
Coolmate ™ V3 #043 009 115 VAC 5/8-18 left-hand inlet/outlet receptacles
Coolmate ™ 4 #042 288 115 VAC 5/8-18 left-hand inlet/outlet receptacles
Coolant Solution
Low Conductivity #043 809 Case of four—1 gallon bottles
Aluminum Protecting #043 810 Case of four—1 gallon bottles
Miscellaneous
Coolant Hoses One coolant “out” and one coolant “in” hose required. One end 5/8-18
left-hand male fitting and the other end “slip-on” secured with hose clamp.
5/16 ID hoses must be compatible with coolant.
Air Hoses Air supply to air filter to back of controller.
Air Filter has 1/4 in pipe thread female fittings.
Controller has 5/8-18 left-hand thread female fittings.
Input Power Cord To be supplied by local source to meet local electrical codes and guidelines.
Date: Total Quoted Price:
Ordering Information
Normally 5/8-18 left-hand
threaded receptacles
Slip-on hoses
tighten with
hose clamps
Input power line
Foot switch
Coolmate TM V3
circulator
Air in
Coolant line
Coolant line
Air hose 60 – 100 PSI
SSW
Pedestal
Air filter/regulator
assembly
Order tongs and tips separately.
Also required:
Input power cord of proper size per
NEC and local codes.
Coolant source and two coolant
hoses (5/16 ID). Hoses must be
compatible with coolant.
Note: Oxy-acetylene hoses are not
compatible with ethylene glycol.
Air hoses.
Stationary Resistance Spot
Welding Basic Equipment
Typical Installations