Miele GAS COMBISET CS 1011 - Manual (Page 19)

Burner
The burner can be dismantled and
cleaned when cool.
^ Remove the burner parts and wash
them in a solution of hot water and
liquid dish soap. Dry them
thoroughly. Make sure that the flame
holes are clean and completely dry.
^ Wipe the burner base clean with a
damp cloth and then dry.
^ Gently wipe the ignitor and ignition
safety control with a slightly damp
cloth, and then wipe dry.
Make sure that no liquid gets into
the appliance.
Reassembling the burner
After cleaning the burner reassemble in
the correct order:
^ Place the burner head j onto the
burner base m, making sure that the
thermocouple k and ignitor l align
through the holes in the burner head.
The notch
a on the burner cap must
securely fit into the recess of the
burner
b.
The notch
c on the burner must
securely fit into the recess in the
lower part of the burner base
d.
^ Fit the burner ring i.
^ Seat the burner caps g and h into
place.
^ Put the grates in place.
Be careful not to mix up the parts.
Cleaning and care
19