Marantz PMD505 - Manual (Page 9)

4
ENGLISH
FRAN
Ç
AIS
ESP
A
Ñ
OL
¼ The operations described below apply to deck A and deck B alike.
¼ Switch on your amplifier or receiver.
¼ Set the Function Selector or Tape Monitor switch on your amplifier or receiver to TAPE or Tape monitor position.
¼ The numbers in the illustration below depict the order in which operation steps are carried out.
RESET
MIN
–
PHONES
CONTROL
PITCH PLAY +
RESET
COUNTER COUNTER
REC/PLAY
EJECT
A
PLAY PLAY
HIGH PAUSE NORMAL REC MUTE REC REC LEVEL SYNC REV
STOP
POWER ON/OFF
STOP
CCONT. PLAY
B
OFF
PLAY
OFF
REC
C
B
REV. MODE
DOLBY NR
CASSETTE DECK PMD505
EJECT
TIMER
MAX
DUBBING SPEED
AUTO TAPE SELECT/HIGH SPEED DUBBING
AUTO REVERSE
AUTO TAPE SELECT/HIGH SPEED DUBBING
AUTO REVERSE
r e
q w u y t
1. Press the POWER switch q to the ON ( ) position.
2. Press the EJECT button w to open
the cassette compartment cover e.
3. Load the cassette tape and close the cassette compartment cover
e.
4. When listening to a tape that has been recorded with Dolby noise
reduction, set the DOLBY NR switch r to match the system used
at the time of recording.
6. Press the PLAY ( or ) button y to being playback.
OFF
C
B
DOLBY NR
5. Select the type of tape transport with the REV MODE switch t.
REV. MODE
Mode
To listen to one side only
To listen to playback of both sides
To listen to continuous play back of
both sides and both decks.
Switch position
7. Press the STOP ( ) button u to stop the playback.
¼ In the continuous playback mode (REV MODE set to ),
playback of both tape sides will be repeated 5 times and then
stop automatically.
¼ If different types of Dolby noise reduction are used for record
and playback, playback response will be adversely effected.
¼ When power is turned off during tape transport, it may not be
possible to remove the cassette by pressing the EJECT
button. In this case, turn on power again before you press the
EJECT button.
Transport Direction
Forward
Reverse
Indicator
1. REV MODE set to q.
2. Press the PLAY ( ) button w of the deck you first wish to listen
to.
3. To stop relay play, press the STOP ( ) button e of the deck
currently playing the tape.
¼ Relay play will play deck A and B in succession for 5 times,
upon which playback stops (Deck A Ǟ Deck B Ǟ Deck A Ǟ
Deck B Ǟ Deck A) or (Deck B Ǟ Deck A Ǟ Deck B Ǟ Deck A
Ǟ Deck B).
RESET
MIN
–
PHONES
CONTROL
PITCH PLAY +
RESET
COUNTER COUNTER
REC/PLAY
EJECT
A
PLAY PLAY
HIGH PAUSE NORMAL REC MUTE REC REC LEVEL SYNC REV
STOP
POWER ON/OFF
STOP
CCONT. PLAY
B
OFF
PLAY
OFF
REC
C
B
REV. MODE
DOLBY NR
CASSETTE DECK PMD505
EJECT
TIMER
MAX
DUBBING SPEED
AUTO TAPE SELECT/HIGH SPEED DUBBING
AUTO REVERSE
AUTO TAPE SELECT/HIGH SPEED DUBBING
AUTO REVERSE
w
q e
¼ Load a cassette tape into deck A and B, and set the Dolby NR button correctoly.
RELAY PLAY (continuous playback of the tapes in deck A and deck B)
PLAYBACK