Miele F 456 i-3 - Manual (Page 40)

Building in the appliance
^ Push the appliance into its housing
unit.
When doing this, make sure that the
mains cable does not get trapped.
^ Depending on the thickness of the
appliance housing unit walls, push
the appliance into the niche until
– the spacer piece touches the
housing unit wall
a (16 mm thick
walls), – or the front edges of the
hinges are flush with the side walls of
the housing unit
b (19 mm thick
walls).
The cover strip must not protrude in
front of the edge of the housing unit.
It must disappear completely into
the niche.
^ Push the hinged side of the
appliance to the furniture wall.
^ Align the appliance by altering the
height of the adjustable feet using the
spanner supplied
f.
^ Secure plastic bracket c to the side
opposite the hinges using the M5 x
22 screws
d.
^ Push the appliance in until the plastic
bracket is flush with the front edge of
the housing unit floor
e.
^ To fix the appliance to the housing
unit at the top and bottom
– screw the 4 x 19 mm long chip board
screws
a loosely into the hinge
plate,
Building in the appliance
40