Miele F 456 i-3 - Manual (Page 41)

– screw two 4 x 19 mm long chip
board screws
b loosely into the
middle of the long slot on the plastic
bracket and then turn the plastic
bracket downwards,
– Align cover strip
d so that it is
parallel to the housing unit ceiling.
It must not protude.
– Fit screws
c into cover strip d.
^ Close the appliance door.
Fitting a furniture door
^ A gap of 8 mm a must be set
between the appliance door and the
fixing bracket.
^ Push fitting aids d up to the height of
the furniture door: the lower edge "X"
of the fitting aids must be at the same
height as the upper edge of the
furniture door being fitted - see
- on
the diagram.
^ Undo nuts b, and remove fixing
bracket
c, together with the fitting
aids.
^ Using a pencil, mark a line down the
centre of the wrong side of the
furniture door.
^ Hang the fixing bracket with the
fitting aids
a onto the
wrong side of
the furniture door. Align the fixing
bracket centrally.
^ Attach the fixing bracket securely
using at least 6 short 4 x 14 mm chip
board screws
b. (On cassette doors
only use 4 screws on the edges).
^ Pull the fitting aids upwards to
remove them
c.
^ Turn them round and fit them back
into the middle slots on fixing bracket
d.
Building in the appliance
41