Selecting beeper volume, Beeper definitions, Quick reference guide 11 – Motorola LS7708 User Manual

Page 11

Advertising
background image

Quick Reference Guide

11

Selecting Beeper Volume

The scanner emits a short beep when it successfully reads a bar code. The volume of
the beep is changed by scanning one of the beeper volume bar codes in the LS7708
Product Reference Guide
, or by using the Volume Control & Wakeup button on the front
of the scanner as follows:

1.

Press and hold the button for approximately five seconds. The scanner cycles
through three settings (low, medium, high), emitting a two-beep tone at each
setting.

2.

To select a particular setting, release the button after the desired 2-beep tone
is heard.

Beeper Definitions

The scanner communicates with the user by emitting different beeper sequences and
patterns. See the Standard Beeper Definitions table for beeper sequences that occur
during both normal scanning and while programming the scanner.

Beeper Sequence

Indication

Standard Use

3 short high beeps

Power up.

Short high beep

A bar code symbol was decoded (if decode
beeper is enabled).

4 long low beeps

A transmission error was detected in a scanned
symbol. The data is ignored. This occurs if the
scanner is not properly configured. Check
option setting.

5 low beeps

Conversion or format error.

Hi-hi-hi-lo beep

RS-232 receive error on RS-232 host or RS-232
auxiliary port.

Code 39 Buffering

Hi-lo beep

New Code 39 data was entered into the buffer.

3 long high beeps

Code 39 buffer is full.

Advertising