Marantz DV4300 - Manual (Page 19)

ENGLISH
15
4. DVD Function
1. TOP MENU !8
Used to display the title menu of the loaded DVD disc. This
function is disc dependent. A DVD disc may not contain the title
menu. (Page 19)
2. MENU
r
Used to display the contents menu of the loaded DVD disc. This
function is disc dependent. A DVD disc may not contain a con-
tents menu. (Page 19)
3. (ANGLE
!1)
Used to select a different angle when the loaded DVD disc sup-
ports multiple angles. This function is a disc dependent. Many
DVD discs don’t support multiple angles. (Page 23)
4. SUBTITLE @4
Used to change the subtitle language to a different language or
off from the one selected at the initial settings, when the loaded
disc supports multiple languages. (Page 23)
5. AUDIO @5
Used to change the audio language to a different language from
the one selected at the initial settings, when the loaded disc sup-
ports multiple audio languages. (Page 22)
5. SETUP Function
1. ARROW @0,
Used to move to the desired menu and moves the image center
of an enlarged screen in zoom mode. Also can be used in marker
or display function.
2. ENT(ENTER
y)
Used to select the menu item. When pressed during STOP,
PAUSE, STEP, SEARCH or SLOW state, it also cancels the
current state and converts to PLAY mode.
3. SETUP
i
Sets up the various operation information of this unit to custom-
ize DVD performance. (Page 32)
• This remote control supports two remote control codes: DVD1 and DVD2.
• When the unit is shipped from the factory, the remote control is set to DVD1.
• To set the remote control to DVD2, hold down both the “ (Stop)” button and the “2” number button on the remote control for at least five
seconds. (If the batteries in the remote control are replaced while the remote control is set to DVD2, the setting will revert to DVD1.)
• To set the remote control back to DVD1, hold down both the “ (Stop)” button and the “1” number button on the remote control for at least five
seconds.
• To check which remote control code is set at STOP mode, hold down both the Stop and PAUSE buttons; the current setting (either “DVD1” or
“DVD2”) will be displayed in the display window on the main unit.
• Also set the REMOT CODE on the main unit to the same setting as the remote control.
Press SETUP buttom for longer than five seconds in stop mode.
Use the Up/Down buttom ( / ) to select the type of REMOTE CODE (DVD1/DVD2), and press ENTER you want to set.
To exit the REMOTE CODE setting, press SETUP.
(This setting is set to DVD1 when the unit is shipped from the factory.)