Miele DA2210 - Manual (Page 13)

Filter timers
Grease filter timer
A timer monitors the hours of operation.
The indicator for the grease filter will
light after 30 hours of fan operation. The
grease filters must then be cleaned.
After the grease filters have been
cleaned and put back in place, the
grease filter timer must be reset.
^ To do this press the grease filter
button for about 3 seconds.
The indicator will go out.
To change the hours of operation, see
"Reprogramming the timers".
Charcoal filters
The timer for the charcoal filter is not
preset. To program this timer, see
"Operation / Reprogramming the
charcoal filter timer". The charcoal filter
indicator will light, once the selected
time has elapsed. The charcoal filters
must then be replaced and the
charcoal filter timer must be reset.
^ To do this, press the charcoal filter
button for about 3 seconds.
The indicator will go out.
Checking the filter timers
To check the percentage of time set
already used:
^ Press the joystick to the left to turn
the fan on.
^ Press the grease filter or charcoal
filter button.
The number of flashing indicators show
the percentage of programmed hours
that have been used.
1 indicator = 25 %
2 indicators = 50 %
3 indicators = 75 %
4 indicators = 100 %
This information will remain stored in
memory in the event of a power failure.
Operation
13