Miele DA2210 - Manual (Page 31)

Installing the joystick
^ Screw the spring into the socket and
tighten by hand. At the same time
hold the socket using a SW 9 wrench,
do not rotate.
^ Screw the base onto the spring and
tighten by hand. Again, hold the
socket with the wrench, do not rotate.
^ Place the bottom section of the
joystick onto the base and loosely
secure it in place with the included
screw and spring washer. Turn the
printing on the bottom section so that
the
m-symbol faces the front.
^ Tighten the screw with a 3 mm Allen
wrench. At the same time hold the
socket with the wrench, do not rotate.
Joystick extension
The joystick can be extended for an
easier reach.
^ Place a spring washer between the
joystick base and the extension.
Tighten the extension by hand while
holding the joystick base with a
wrench.
^ Attach the lower part of the joystick to
the extension with a spring washer.
Turn the
m-symbol to the front and
screw in place with an allen wrench
while using a wrench to hold the
joystick base.
Installation
31