Miele G 7823 - Manual (Page 47)

Interrupting a programme
A programme can only be
interrupted in operating level B or D.
If you absolutely have to open the door,
e.g. because the load is obviously
unstable (conscious intervention):
After interrupting a DESIN
disinfection programme, if you wish
to continue it please check the
message in the display at the end of
the programme. If the message
PROCESS PARAMETERS NOT MET
is displayed, it means the door was
opened after the disinfection part of
the programme and the DESIN
parameters were not fulfilled. If
necessary the programme must be
repeated.
In operating levels B or D
^ Press the Stop button 7.
The programme is interrupted.
CANCEL or
üCONTINUE< will appear
in the display.
^ Open the door.
On barrier machines please note: If
the machine is set to WITHOUT DOOR
INTERLOCK - YES the doors on either
the clean or unclean side can be
opened. If it is set to WITHOUT DOOR
INTERLOCK - NO only the door on the
unclean side can be opened at this
stage.
Washer-disinfectors used as
medical devices (in accordance with
EN ISO 15883) should always be set
to WITHOUT DOOR INTERLOCK
NO.
,
Caution. Water and items in the
machine may be hot. Danger of
burning or scalding.
Where a chemical disinfection
programme has been used, be
aware that steam may contain high
quantites of disinfecting agent.
^ Rearrange the load. Follow infection
control regulations and wear
protective gloves.
^ Close the door.
^ Press the Start button 6.
The programme will continue.
Operation
47