Miele G 7823 - Manual (Page 42)

Master switch
The master switch with "emergency
cut-off function" is set to I-ON.
Switching on
^ Open the stopcocks (if turned off).
^ Press the I-0 button.
In operating levels A, B and D the most
recently selected PROGRAMME NAME
appears in the display and in operating
level C AUTOMATIC MOBILE UNIT
RECOGNITION is displayed.
Door lock
The door can only be opened if:
– the electricity supply to the machine
is switched on,
– the red (emergency cut out) master
switch is in the I-ON position,
– the I-0 On-Off button is pressed in,
and
– a cleaning or disinfection programme
is not in progress.
To open the door
^ Press the 5 door button, and holding
onto the door grip open the door.
To open the door on the Clean side
(through-feed model), the following
conditions must also be met:
– DESIN (disinfection) programmes
have been correctly completed,
or
– the door locking function is active
(see "Machine function/Door
Interlock" in the Programming
manual).
,
Do not touch the heating
elements under the wide area filter
during or directly after the end of a
programme. You could burn
yourself. They remain hot for some
time after the programme has
finished.
If the boiler has been programmed
to BOILER READY, be particularly
careful of hot water and steam when
opening the door. Danger of burning
or scalding. The inlet to the wash
cabinet is located, as viewed from
the unclean side, underneath the
basket runner on the left hand side.
To close the door
Lift the door upwards and push until it
clicks shut.
Operation
42