Maytag W10304917A - Manual (Page 13)

13
OVEN CAVITY
Food spills should be cleaned when oven cools. At high
temperatures, foods react with porcelain and staining, etching,
pitting or faint white spots can result.
On some models, the oven door can be removed. See the “Oven
Door” section first.
Cleaning Method:
■ Steel-wool pad
■ Oven cleaner: Follow product label instructions.
OVEN RACKS AND ROASTING RACKS
Cleaning Method:
■ Steel-wool pad
BROILER PAN AND GRID (on some models)
Cleaning Method:
Wash in warm soapy water. (It is not recommended to wash the
chrome grid in a dishwasher.)
A mild abrasive cleaner and a plastic scrubber can be used to
remove stubborn stains.
For heavily soiled bowls, place an ammonia soaked paper towel
on the stains and allow to soak for a short time, then gently scrub
with a plastic scrubber.
Porcelain enamel only
■ Warm soapy water or dishwasher
■ Oven cleaner: Follow product label instructions.
Oven Light
The oven light is a standard 40-watt appliance bulb. Press the
manual oven light switch on the backguard to turn on and off.
Before replacing, make sure the oven and cooktop are cool and
the control knobs are off.
To Replace:
1. Unplug range or disconnect power.
2. Turn bulb counterclockwise to remove from socket.
3. Replace bulb.
4. Plug in range or reconnect power.
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open the oven door. Insert hinge pins, included with your
range, into both hinge hangers. Do not remove the pins while
the door is removed from the range.
2. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
3. Pull door straight up, then toward you. Do not remove hinge
pins until the door is replaced on the range.
To Replace:
1. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
2. Hold oven door so that the top edge of each door slot is
horizontal. Insert door hinge into the hinge slots.
3. Tilt top of door toward range. Insert bottom door hinge notch
down onto front frame edge.
4. Open the door completely and remove the hinge pins. Save
hinge pins for future use.
5. Close the door slowly to assure door side panel clearance
and proper hinge engagement.