Maytag W10304917A - Manual (Page 8)

8
ELECTRONIC OVEN CONTROL
Display
When power is first supplied to the appliance, a flashing time will
appear on the display. Press CANCEL to clear flashing time from
the display.
If flashing time appears, a power failure has occurred. Press
CANCEL and reset the Clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a cook or timer function, the display will show
either hours and minutes, or minutes and seconds.
Oven Indicator Lights
The indicator lights are located on both sides of the display. The
indicator lights light up or flash when the oven is in one of the
following modes: Bake, Broil or Kitchen Timer.
Start
The START pad begins any oven function. If the START pad is not
pressed within 5 seconds after pressing a function pad, the Push
to Start (“PSH”) indicator light will flash and the push to start tone
will sound as a reminder.
If the START pad is not pressed within 1 minute after pressing a
function pad, the oven display will return to the time of day mode
and the programmed function will be canceled.
Cancel
The CANCEL pad stops any function except the Clock, Kitchen
Timer and Control Lock.
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the oven and Kitchen Timer are off.
1. Press CLOCK.
2. Press the TEMP/TIME “+” or “-” pads to set the time of day.
3. Press CLOCK or START.
Tones
Tones are audible signals, indicating the following:
One tone
■ Valid pad press
■ Oven is preheated (long tone)
■ Function has been entered
Three tones
■ Invalid pad press
■ Push to start reminder
Cycling tones
■ End of cycle
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To Change: Press and hold BROIL for 5 seconds. A tone will
sound, and “C” will appear on the display. Repeat to change
back to Fahrenheit. To exit mode, press CANCEL.
Kitchen Timer
The timer can be set in hours or minutes up to 12 hours and
59 minutes, and counts down the set time either in hours and
minutes, or in minutes and seconds. The timer does not start or
stop the oven.
To Set:
1. Press KITCHEN TIMER. The timer indicator light will light up.
If no action is taken after 1 minute, the display will return to
the time of day, bake or broil mode.
2. Press the TEMP/TIME “+” or “-” pads to set the length of
time.
3. Press START. When the set time ends, end-of-cycle tones will
sound.
4. Press KITCHEN TIMER pad twice anytime to cancel the timer
and reminder tones.
If the CANCEL pad is pressed, the oven will turn off and the cook
function will be disabled.
To display the time of day for 5 seconds when the timer is
counting down, press CLOCK pad.
If the START pad is not pressed within 5 seconds after pressing
the KITCHEN TIMER pad or TEMP/TIME arrow pads, the “PSH”
indicator light will flash and the push to start tone will sound as a
reminder.
The timer can be reprogrammed to change the time while it is
running.
To Reprogram:
1. Press KITCHEN TIMER.
2. Press TEMP/TIME “+” or “-” pads to adjust time.
3. Press START.
A. Oven light
B. Clock
C. Display
D. Start (control lock)
E. Cancel
F . Timer
G. Bake
H. Broil
I. Temp/time
A B C D E
F G H I