MACKIE PPM1008 - Manual (Page 8)

8
PPM1008
PPM1008
DJ System
This diagram shows a wireless microphone receiver connected to the channel 1 line input, a graphic
EQ connected to channel 1's insert jack (to help control feedback in the wireless mic), a microphone
connected to channel 2, and an iPod docking station attached to channel 8's RCA inputs.
A Mackie d.2 Pro DJ production console is connected to two turntables, and its RCA output connects to
the powered mixer's channel 7 stereo RCA inputs. Use the d.2 Pro's advanced DJ controls to get the best
performance from your records. Use the powered mixer to play the d.2 Pro output, and control the mics
and iPod.
The power amp mode switch is set to play the stereo main mix in the C300z passive speakers,
connected to the speaker-level power outputs.
Passive subwoofers are powered by an amplifier connected to the main mix sub out, to reinforce the
low end in your main mix.
Microphones
Wireless
Microphone
Rear Panel
Front Panel
Power Amp Mode
switch set to
Stereo Mains
LINE MIC
R R
PGM 2 MAIN OUT MIC
L L L L L R PHONO CD SEND R
BOOTH FX
GND LINE PHONO
RETURN
L(MONO) R R
L
R
LIVE RECORD
~100-240 VAC 50-60Hz 20W
PGM 1
LINE PHONO GND
PHONO CD
R R
L L
Wireless Mic
Receiver
Graphic EQ
Turntables with phono-level output
Mackie d.2 Pro
DJ Production Console
iPod TM Docking Station
Power
Amplifier
Passive Subwoofers
(plays main mix below 100 Hz)
C300z Passive Speakers
(plays stereo main mix)