Multiquip Mayco Concrete Pump LS600 - Manual (Page 45)

MAYCO LS600 PUMP — OPERATION AND PARTS MANUAL — REV. #4 (9/15/11) — PAGE 45
LS600 PUMP — MAINTENANCE (TRAILER)
Periodically check the actuator mounting fasteners for
damage or loosening. Inspect the actuator for worn or damaged
parts. As you are towing your trailer, be aware of any changes
in braking quality. This could be an early warning of brake or
actuator malfunction and requires immediate
attention. Consult a certified brake specialist to make
necessary adjustment or repairs.
Adjustable Channel
Your trailer may be equipped with an adjustable channel
(Figure 47) that allows the coupler to be raised or lowered
to a desired height. Periodically check the channel bolts for
damage or loosening.
Figure 47. Adjustable Channel
With Pintle Eye Coupler
 Replace bearings that have flat spots on rollers, broken
roller cages, rust or pitting. Always replace bearings
and cups in sets. The inner and outer bearings are to
be replaced at the same time.
 Replace seals that have nicks, tears or wear.
 Lubricate the bearings with a high quality EP-2
automotive wheel bearing grease.
Wheel Hub Adjustment
Every time the wheel hub is removed and the bearings are
reassembled, follow the steps below to check the wheel
bearings for free running and adjust.
 Turn the hub slowly, by hand, while tightening the spindle
nut, until you can no longer turn the hub by hand.
 Loosen the spindle nut just until you are able to turn it
(the spindle nut) by hand. Do not turn the hub while
the spindle nut is loose.
 Install a new cotter pin through the spindle nut and
axle.
 Check the adjustments. Both the hub and the spindle
nut should be able to move freely (the spindle nut
motion will be limited by the cotter pin).
Wheel Bearings (Hubs)
Wheel bearings (Figure 48) must be inspected and lubricated
once a year or 12,000 miles to insure safe operation of your
trailer.
If a trailer wheel bearing is immersed in water, it must be
replaced.
If the pump/trailer has not been used for an extended amount
of time, have the bearings inspected and packed more
frequently, at least every six months and prior to use.
Follow the steps below to disassemble and service the
wheel bearings.
 After removing the dust cap, cotter pin, spindle nut
and spindle washer, remove the hub and drum to
inspect the bearings for wear and damage.
Figure 48. Wheel Hub Components
WHEEL
HUB
BEARING
CUP
BEARING
CONE
OIL
SEAL
CASTLE
NUT
SPINDLE
WASHER
COTTER
PIN
DUST
CAP LUG
NUT
If trailer wheels are under water for a long period of
time, wheel bearings may fail. If this is the case, service
wheel bearings immediately.
The possibility exists of the wheels falling off, causing
equipment damage and severe bodily harm even death!
DANGER - Wheel Bearings