Basic options – Multi-Tech Systems MT5600BL-V.90 User Manual
Page 23
Chapter 3 - Using the Front Panel
23
Multi-Tech Systems, Inc. MT5600BA/BL Series User Guide (S000276E)
B
B
B
B
Basi
asi
asi
asi
asic Opt
c Opt
c Opt
c Opt
c Optiiiiio
o
o
o
ons
ns
ns
ns
ns
The following screens are used to configure the modem’s basic operating conditions.
ONLINE OPTIONS.
The following screens are used to configure the online operation
of the modem:
LINE TYPE OPTIONS.
Use the
Ж
Ж
Ж
Ж
Ж and
Enter
buttons to select
from the following line types: dial-up (PSTN), two-wire leased
line originate or answer, and four-wire leased line originate or
answer.
ERROR CORRECTION OPTIONS.
Use the
Ж
Ж
Ж
Ж
Ж and
Enter
but-
tons to turn error correction on or off, or to select automatic error
correction. Same as the
&
E0
,
&
E1
, and
&
E2
commands.
FLOW CONTROL OPTIONS.
Use the
Ж
Ж
Ж
Ж
Ж and
Enter
buttons to
select no flow control, hardware flow control, or software flow
control. Same as the
&
E3
,
&
E4
, and
&
E5
commands.
DIALING OPTIONS.
The following screens are used to configure dialing options or
to dial manually.
TONE/PULSE.
Use the
Ж
Ж
Ж
Ж
Ж and
Enter
buttons to select between
DTMF tone dialing and pulse dialing. Same as the
T
and
P
com-
mands.
BLIND/SMART DIAL OPTIONS.
Use the
Ж
Ж
Ж
Ж
Ж and
Enter
buttons
to select blind dialing, in which the modem sends the
OK, CON-
NECT, RING, NO CARRIER, ERROR and NO ANSWER mes-
sages to the computer and does not look for a dial tone or busy
signal, or smart dialing, in which the modem sends all messages
to the computer, including
NO DIALTONE and BUSY. Same as
the
X0
and
X4
commands.
DIAL NUMBER.
Use the front panel buttons to enter a phone
number and dial it. To scroll through a list of digits and charac-
ters, press the
З
З
З
З
ЗЕ
Е
Е
Е
Е and И
И
И
И
И buttons. To go to the next position,
press the
Ж
Ж
Ж
Ж
Ж button. To back up or to exit without dialing, press
the
Ж
Ж
Ж
Ж
Ж button several times. To dial the number, press the
Enter
button. Same as the
D
command.
DTR DIALING.
Use the
Ж
Ж
Ж
Ж
Ж and
Enter
buttons to enable or dis-
able DTR dialing. DTR dialing is popular in synchronous applica-
tions. In DTR dialing, the modem automatically dials the number
stored in memory location 0 when it detects a high DTR (Data
Terminal Ready) signal on the RS-232 interface. The DTR signal
must remain high for the duration of the call. To store the DTR
dialing number, use the
&
Z0=
command or the
ENTER PHONE
#0
menu option.
Note:
Plug and Play does not function if DTR dialing is enabled.
DTR is used during Plug and Play, and DTR dialing interferes
with it.