Marantz SR4002/SR5002 - Manual (Page 21)

18
ENGLISH
CONNECTIONS
SPEAKER PLACEMENT
The ideal surround speaker system for this unit is 7-
speaker systems, using front left and right speakers,
a center speaker, surround left and right speakers,
a surround back left and right speakers, and a
subwoofer.
For best results we recommend that all front speakers
be of the same type, with identical or similar driver
units. This will deliver smooth pans across the front
sound stage as the action moves from side to side.
Your center channel speaker is very important as
over 80% of the dialog from a typical motion picture
emanates from the center channel.
It should possess similar sonic characteristics to the
main speakers. Surround channel speakers need not
be identical to the front channel speakers, but they
should be of high quality.
The surround back speaker is useful for playback
of Dolby Digital Surround EX or DTS-ES. One of
the benefi ts of both Dolby Digital and DTS is that
surround channels are discrete full range, while they
were frequency limited in earlier “Pro Logic’ type
systems.
Bass effects are an important part of home theater.
For optimal enjoyment a subwoofer should be used
as it is optimized for low frequency reproduction. If
you have full range front speakers, however, they
may be used in place of a subwoofer with proper
setting of the switches in the menu system.
90° 110°
22°
30°
135°
150°
0°
Front Right
Front Left
Front Center
Surround Left
Subwoofer
Surround Back
Left
Surround Right
Surround Back
Right
Front left and right speakers
We recommend to set the front L and R speakers
with 45-60 degrees from the listening position.
Center speaker
Align the front line of the center speaker with the front
L/R speakers. Or place the center speaker a little
backward from the line.
Surround left and right speakers
When this unit is used in surround operation, the
preferred location for surround speakers is on the
side walls of the room, at or slightly behind the
listening position.
The center of the center speaker should face the
center of the room.
Surround back left and right speakers
Surround back speakers are required when a full 7.1-
channel system is installed.
Speakers should be placed on a rear wall, behind the
listening position.
The center of the center speaker should face the
center of the room.
Subwoofer
We recommend using a sub-woofer to have maximum
bass effect. As the subwoofer only handles low
frequencies, you can place it any where in the room.
HEIGHT OF THE SPEAKER UNITS
Front left and right speakers, and a center speaker
Align the tweeters and mid-range drivers on the
three front speakers at the same height, as best as
possible.
Surround left and right speakers, and surround
back speaker
Place the surround left, right and surround back
speakers higher than your ears by about 70cm – 1m.
Also place the speakers at the same height, as best
as possible.
70cm
1m
Note:
Use magnetically-shielded speakers for front left, right
and the center speakers when the speakers are installed
near the TV.
CONNECTING SPEAKERS
R R SR SR
C C
SW SW SBR SBR
MULTI. MULTI. OUT OUT
SL SL SBL SBL L L
R R R R
XM XM
R R L L L L L L L L R R
IN IN
OUT OUT REMOTE CONT. REMOTE CONT. OPT OPT DIGITAL OUT DIGITAL OUT ( (AUX2 AUX2) ) 7.1CH INPUT 7.1CH INPUT
L L SL SL C C SBL SBL
R R SR SR SW SW SBR SBR
RS-232C RS-232C SPEAKER C SPEAKER C OFF OFF ON ON
R R
L L
FM FM ( (75 75) ) GND GND AM AM
C CR R // P PR R C CB B // P PB B Y Y C CR R // P PR R C CB B // P PB B Y Y
1 1
ANTENNA ANTENNA
DIGITAL IN DIGITAL IN OUT OUT IN IN CD/CDR CD/CDR OUT OUT IN IN TAPE TAPE VCR VCR DVD DVD TV TV AUDIO AUDIO DSS DSS IN IN OUT OUT
C CR R // P PR R C CB B // P PB B Y Y DSS DSS TV TV DVD DVD VCR IN VCR IN VCR OUT VCR OUT MONITOR OUT MONITOR OUT
MONITOR MONITOR OUT 2 OUT 2
INPUT INPUT 1 1
INPUT INPUT 2 2
S-VIDEO S-VIDEO
VIDEO VIDEO
AC IN AC IN
MODEL NO. SR5002 MODEL NO. SR5002
FLASHER FLASHER IN IN
PRE OUT PRE OUT AC OUTLETS AC OUTLETS
120V 60Hz 120V 60Hz
SWITCHED SWITCHED
1.25A 150W 1.25A 150W CENTER CENTER SURROUND SURROUND SURROUND BACK SURROUND BACK SPEAKER C/MULTI SPEAKER SPEAKER C/MULTI SPEAKER FRONT A OR B.CENTER. FRONT A OR B.CENTER. FRONT A FRONT A + + B : 8 OHMS B : 8 OHMS SPEAKER SPEAKER
SYSTEMS SYSTEMS
FRONT FRONT B B FRONT FRONT A A
SURR.SURR BACK : 6-8 OHMS SURR.SURR BACK : 6-8 OHMS
2 2 1 1
5 5 4 4
DC DC TRIGGER TRIGGER
3 3
INPUT INPUT 3 3
INPUT 3 INPUT 3 OUTPUT OUTPUT INPUT 2 INPUT 2 INPUT 1 INPUT 1
HDMI Ver 1.1 HDMI Ver 1.1 COMPONENT COMPONENT VIDEO VIDEO
SW SW
PRE OUT PRE OUT
R R R R R R L L L L L L L L R R
CENTER CENTER SURROUND SURROUND SURROUND BACK SURROUND BACK SPEAKER C/MULTI SPEAKER SPEAKER C/MULTI SPEAKER FRONT A OR B.CENTER. FRONT A OR B.CENTER. FRONT A FRONT A + + B : 8 OHMS B : 8 OHMS SPEAKER SPEAKER
SYSTEMS SYSTEMS
FRONT FRONT B B FRONT FRONT A A
SURR.SURR BACK : 6-8 OHMS SURR.SURR BACK : 6-8 OHMS
INVERT
OUTPUT INPUT
LEVEL BTL REMOTE CONT. EXT. CONT. IN
VIDEO/ +5~13V DC SYSTEM OUT OUT
INPUT MASTER SLAVE MIN MAX IN
FU S E
SPEAKER SYSTEM
MINIMUM 4 OHMS
Powered
subwoofer
Power
Amplifi er
Passive
subwoofer
Surround
BACK
Center
Left
Surround
Right
Front A
Right Left
Right Left
Front B
Right Left
or
SR5002 only
CONNECTING SPEAKER WIRE
1. Strip away approx. 3/8 inch (10 mm) of wire
insulation.
2. Twist the bared wire ends tight, to prevent short
circuits.
3. Loosen the knob by turning it counterclockwise.
4. Insert the bare part of the wire into the hole in
side of each terminal.
5. Tighten the knob by turning it clockwise to
secure the wire.
1. 2.
3. 4. 5.
10 mm